well here is were my greenery is showing I am not sure how to check that. everything is set to original settings, the only thing I flashed was the fc when I went into cleanflight, this was a rtf drone from jjpro until it hit a rock and I had to find problem. so it started on pwm changed rx from i6a to i6b and tried to work out the original problem and improve as I went along. this is as far as I have gotten. I am going to search for program to flash or at least look at esc program and maybe see if that is were my problem is. would my esc protocols be listed in the dump cli files?

You can't really flash Simon K.

In the configurator, in configuration tab, look for ESC protocol.

I got to blheli app page but it seems my fc firmware doesn't support blheli pass through and I need to upgrade before I can use the page.

Let me correct myself, Simon K is not easy to flash. But you can flash it over to Blheli, depending on the ESC.

my fc has the latest firm ware cleanflight is listing so re-flashing will be a little more of a challenge for me, will need to track down a new naze32 ver 2.1.1 date 7.30.17 but when I got my rx back to pwm an all units and wired esc and motor reacted normally with other 3 units on trial testing. now need to rebind tx secure fc and see what it does then.

well problem  has been solved. thx voodoo, esc pwm protocol was the underling issue. so to recap lost binding with rx board, and changed, flashed fc, test flight crashed and trouble shot a constant beeping motor, replaced esc on motor #2 changed rx protocol to ppm and motor 2 wouldn't work. put everything back to pwm and now all motors are working.

this is all thanks to the forum, it really works you all are very help full even to someone with no experience in drone repair.
special thanks to you voodoo.

just enough help to keep me from smashing my head into a wall but not to much that I didn't think for myself.

Great. Glad everything is working.