Good morning everyone. Can anyone help share the CLI Dump file for the Diatone Mamba F722 35A MK1 please. I did a reset on betaflight and am unable to locate the backup file in my computer. Please help me. Thank you.

Dr. Saravanan

If this is just a plain flight controller that isn't installed in a BNF quad then all you need to do is to run the "defaults" command in the CLI and it will set the configuration back to the default values for the installed Betaflight target.

If you have flashed the wrong target to the FC by mistake then you just need to flash the MAMBAF722 target to it, then connect Betaflight Configurator to the FC and click on the "Apply Custom Defaults" button when prompted.

Hi SnowLeopardFPV. It is a BNF with the following build:

DIATONE Roma L5 Freestyle Multirotor (6S) PNP
Camera: RUNCAMPHOENIX 2
Antenna: MAMBA UltraRHCP
VTX: MAMBA Ultra Tiny 400mW
FC:MAMBA F722 AIO MK1
ESC:MAMBA 35A 8BIT
Motor: MAMBA2004 1700KV
GPS ：M8PLUS

Is there another work around for me? Can i reconfigure from scratch? Please advise. Thanks

Hi, i found this off the net.

https://drive.google.com/file/d/1kT04KVc...sp=sharing

Can i use this? Thanks

(15-Jun-2021, 09:41 AM)Doc Wrote: Hi, i found this off the net.

https://drive.google.com/file/d/1kT04KVc...sp=sharing

Can i use this? Thanks

hi, ive made the same mistake, LOOK IVE JUST FOUND THIS  ( https://www.rcgroups.com/forums/showthre...nalogue%29 ) we are save!!!