https://www.happymodel.cn/index.php/2022...-receiver/



i would like to get pwm signal for two servos, i saw the led pad. is the tx2 pad also a timed pad? or is there another source i could use?

thank you for any help :-)

All of the following breakout pads have a timer resource and can therefore be remapped as a Servo output:

• Any of the motor pads
  
• Any of the UART pads
  
• The LED Strip pad
  

The BUZ- pad is just a switched output without an associated timer so that one is off the table. I don't see any other breakout pads that could be used and because the F411 chip is a BGA type MCU there is no option to try and directly solder to to any of the legs, because it has pads on the underside and not exposed legs.

thank you snow, it will work than as i only need two pwm signals
i has two of these aios, with some broken esc on it. would bw nice if i could make some nice small 1s fpv planes out of them :-)