cli_dump.txt (Size: 27.32 KB / Downloads: 51)

I just recieved the bind and fly Diatone Roma 5 v2 with Mamba DJI F722 MK2 flight controller.
I soldered up the reciever exactly how it said to Ch 1 of the nano RX to RX1 on FC,  and Ch 2 to TX1 on FC.

I have serial reciever and Crsx selected in the configuration tab.
Im stuck I have solid green light, but still no stick commands.

Attached is my Cli dump in text file.

Thank's Mack

It looks like you forgot to attach the dump file. Make sure you click "add attachment" after you upload it.

(17-Sep-2021, 03:29 PM)V-22 Wrote: It looks like you forgot to attach the dump file. Make sure you click "add attachment" after you upload it.

Thank's, I uploaded it.  I just updated my crossfire firmware.  But still nothing.

Here is a picture of my flight controller and receiver wiring.
It is wired:
Ch2 on RX to TX1 on FC.
CH1 on RX to RX1 on FC.
Power on RX to 5volt pad on FC.
Ground on RX to Ground on FC.

I updated crossfire firmware to the latest 6.07, and updated RX firmware also. Picture of tx16s crossfire setup below.

Thanks, Mack

Settings look correct, but the picture didn't upload. Please make sure the FC and wiring are clearly visible.

Here are the pics.

   

   

   

Here is the diagram, I have it wired like this.  Incase my picture is not clear.

   

Check for any shorts at the RX/TX pads of both FC and Crossfire.

Are you receiving telemetry on the radio side?

Can you try downgrading the Crossfire version to the last available release (not beta) and test?