Posts: 14
Threads: 3
Likes Received: 0 in 0 posts
Likes Given: 4
Joined: Jan 2018
Reputation:
1 • Posts: 14
Threads: 3
Likes Received: 0 in 0 posts
Likes Given: 4
Joined: Jan 2018
Reputation:
1 toggle-yes ch5 switch/aux1 (top left of radio). When I flip that on motors idle. When I had the 'motor stop' on nothing would happen. I can try those changes.
• Posts: 14
Threads: 3
Likes Received: 0 in 0 posts
Likes Given: 4
Joined: Jan 2018
Reputation:
1 cool. So I added the air mode switch, put 'motor stop' back. What's the benefit of air and arm vs just arm? With just arm I've got one 'kill' switch, with both it seems redundant? Also, added .40 RC expo to roll/pitch in BF. Seems to calm it a little.
• Posts: 1,504
Threads: 83
Likes Received: 944 in 654 posts
Likes Given: 2,142
Joined: Sep 2016
Reputation:
24 Motor stop is to select between your motors spinning when you arm, or keeping the motors still until you apply throttle.
Airmode is great for acrobatics, it keeps the motors spinning even when you are at 0 throttle, so other (not throttle) stick inputs will still effect the attitude of the quad without any throttle being applied. So if you have motor stop on, and airmode on, the motors will still spin when you arm, because airmode will override motor stop.
Most people turn 'motor stop' off, especially with high speed brushless models. When you arm and the motors start spinning, there is an unmissable display that the quad is armed and could turn into 90kmh+ of blades and carbon fiber in under a second.
Windless fields and smokeless builds
Posts: 123
Threads: 13
Likes Received: 25 in 23 posts
Likes Given: 33
Joined: Jan 2018
Reputation:
0 sky is the place, gravity is the enemy, and the challenge to overcome.
Posts: 123
Threads: 13
Likes Received: 25 in 23 posts
Likes Given: 33
Joined: Jan 2018
Reputation:
0 ok I have a question, flashed my naze32 2.210 and now when I move my sticks any direction it ramps up the motors. I have been fighting with this thing for 2 weeks and finally got a fs6brx and run ppm. tx is finally talking but what do I do about the motor ramping???? very new at this and wife is laughing in my face.
•