I've been working with a couple of high school kids off and on for a few months as part of their physics class (where they always learned to solder) to build quadcopters.  Yesterday we got 99.9999% of the way there.  The only problem we have left is that their FlySky FS-i6 transmitters are mapping Channel 5 and 6 to the dials on top, rather than to any of the 4 switches available.  This means their arm is based off a dial right now.  I have 0 experience with this TX so I'm looking for help.

See this gets you what you need?

http://diydrones.com/profiles/blogs/flys...ight-modes

(08-Dec-2016, 07:24 PM)illushinz Wrote: See this gets you what you need?

http://diydrones.com/profiles/blogs/flys...ight-modes

Menu - setup - aux channel - source and select the switch you want to use

Awesome! Thank you very much!

(08-Dec-2016, 09:57 PM)jamesw Wrote: Awesome!  Thank you very much!

Hope we helped!

-and kids are taking physics in High School now?  Awesome!  Time to teach them all about PID loops, they apply to almost every automated control system out there.