Hey Guys

I rouched the positive and negative leads on camera by accident checking voltage input! It completely fried the trace which peeled off the board. So, camera signal is not working at all. I wired the cam to the vtx vand its oerfect but obviously no OSD. This a vrand new Flight controller Id like to get the cam working with OSD if possible.. can I remap the cam signal to another pad like led signal? Is it possible to bypass cam signal and go straight to the osd chip? If not ill run through vtx for now, grab a new fc and use this one for a beater quad.

No you can't remap the cam signal. You can try to follow the trace and see if you can scrap the coating and solder a thin wire to it. Or find the next component it is connected to and solder to that. Probably the easiest way.

Otherwise, you can look at the schematics of the OSD chip. Likely the MAX7456 chip. Find the output pin. I think there is a few caps and resistor after the pin before it goes to the camera the last time I looked at the schematic. Which brings you back to the component.

If I get a chance, I will look at the OSD chip schematic.

Edit : You should look for a 75ohm resistor.