Hi,

I use a F3 brushed FC (http://www.banggood.com/Realacc-F3-V1_0-...21378.html) but have some problems after I changed the frame.

My last frame was broken during a crash so I replaced it with a new one. However, from now on I can't really control the throttle anymore. As soon as I arm and give a little bit of throttle, the motors spin up fast and get incrementally faster (so fast, the quad would lift up). When I give full throttle, it seems that I can still spin up the motors a little bit faster.

When I go to the motors tab, I can continously spin up and down the motors without problems.
ESC set to brushed, PWM set to 32000 and min/max command set to 1000/2000.
I also reflashed the firmware.

I flew it fine before, but know I can't get it to work right. Could it be, that the FC is somehow damaged (although I can control the motors fine in the motors tab)?

Can you check motor order? Use the motor tab in configurator:

4 2

3 1

It could be that your FC is mounted the wrong orientation...

If this is happening on the bench with no props on, this is expected behaviour as the flight controller is trying to fly the quad.