I have been trying a bunch of different props on my Tyro79 and needed a better way of tightening the nuts.
Here is a simple wrench that can be scaled up or down to fit any motor. I designed it in Solid Edge and printed it with PLA. It has a little recess for a strip of rubber to add some grip. The rubber has some 2 sided tape on it and is 1mm thick

It works pretty well

https://www.thingiverse.com/thing:3701195

And check out those sexy "Whiskey" colored props from Gemfan, They match the frame and motors 







Scott

Nice work  When I get me a 3D printer I'll certainly print one of these off

Nice design. Guess it gives me a reason to fire the printer up again.

Deal

Good one!
Where do we get that rubber strip?

(20-Jun-2019, 02:55 PM)Oscar Wrote: Good one!
Where do we get that rubber strip?

I just cut a piece from the one supplied for the battery bottom plate.



But I imagine most folks could find a piece around the house. Old inner tube or one of those gripy things to open jars.


Scott

Simple and clever! Loved it

Thanks to all !

It works pretty good.

Scott